Step 1:
I taped tin foil to a paper of about 20x20 cm or 8x8 inches, see next picture.

Step 8:
Repeat step 7 on the right and left, see arrows.

Step 6:
Repeat step 5 on the other three flaps.

Step 13:
Fold over these 5 lines, fold the model in half
first, then make the other folds.

Step 12:
Pull the edge of the ends on the backside
over the ends in front.

Step 11:
Repeat step 9 and 10 on the left, see arrow

Step 10:
Press the model flat, so the end stays on its
place.

Step 9:
Pull the end on the backside a little to the
right, see arrow.

Step 5:
Squash-fold the flap.

Step 7:
Make the same folds on the backside.

Step 3:
First, valley-fold over the 2 lines at the bottom right. Then, mountain-fold over the 2 diagonal lines in the middle. And valley-fold over the 2 lines at the top left.

Step 2:
Prefold over these 4 lines.

Step 4:
Valley-fold this flap upwards.

Step 15:
Curl / curve the ends by rolling them up
between your fingers.

Step 14:
Press this spot flat between your fingers.

Done!
This is a DIY-video with instructions for the fork (step 12 is not in the video):

Step 16:
Wrap transparent tape around this spot,
see arrow.

Who's doing the dishes?!
Good question!