Step 2: First
valley-fold over the 2 lines at the bottom right.
Then mountain-fold over the 2 diagonal lines in the middle. And
valley-fold over the 2 lines at the top left.
Step 4: Squash-fold
Step 3: Valley-fold
one flap straight upwards.
Step 10: Mountain-fold
the triangular flap to the inside.
Step 8: Valley-fold
the triangular flap upwards.
Step 9: Pull
these 2 ends outwards, in the direction of the arrows.
Step 7: Press/push
these edges downwards/flat.
Step 1: The
other side of this paper is orange.
Prefold over these 4 lines, then turn the paper.
Step 16: Push
this corner downwards by making an inside reverse fold over these 3
Step 15: Bookfold
to the right
Step 12: Repeat
steps 4 to 11 on the other three flaps.
Step 11: Push
the two ends towards each other again.
Step 14: Valley-fold
over this line.
Step 13: Bookfold
one layer to the left.
Step 21: Valley-fold
over these 4 lines, to reveal more of the orange side.
Step 19: Repeat
steps 14 to 18 on the left,
Step 20: Valley-fold
over this line.
Step 18: Push
this edge to the right, see pink arrow.
Step 17: Mountain-fold
over these 2 lines.
Step 22: Mountain-fold
over the two outer lines.
Then valley-fold over the longer line in the middle.
Step 28: Make
the same zig zag folds on the other wing.
Step 25: Make
the same fold (=valley-fold) on the layer below.
Step 26: Press
the orange tip flat between your fingers, see larger arrows.
Press the edge of the neck inwards a little, see smaller arrows.
Step 24: Hold
the model on the spot between the 2 arrows.
Then push the head to the right by making a mountain-fold over the 2
lines on the top left and a valley-fold over the 2 lines at the bottom
Step 23: Fold
over these three lines.
Step 29: Push
these 4 corners inwards with your finger by making an inside reverse
fold over the 4 sets of three lines.
Step 27: Pull
the end out of the model, see small arrow.
This video by Joost Langeveld also has
instructions for the white goose: