Step 1:
The flower paper is 6x6 inch (15x15 cm) and pink on one side.
Prefold in half

Step 6:
Fold over these 3 lines.

Step 5:
Press / fold the model flat.

Step 2:
Fold over these 2 lines, use the next picture as guidance.

Step 4:
Fold both corners inwards

Step 3:
Fold over these two lines. First fold the tip to the spot indicated by the arrow.

Step 10:
Fold over these 2 lines.

Step 8:
Fold over these 2 lines.

Step 9:
Fold in half

Step 7:
Fold over this line

Step 16:
The leaf papers are also 6x6 inch and green on one side. Prefold in half over these 4 lines

Step 15:
Done......

Step 12:
Fold the edge inwards and open the model.

Step 11:
Fold both corners inwards.

Step 14:
Glue or fold the corners together

Step 13:
Sink-fold over the prefolded lines and close the model again

Step 21:
Fold the 2 lower flaps straight upwards.

Step 19:
Fold the tip upwards.

Step 20:
Press / fold these edges downwards.
Repeat steps 18 to 20 on the backside.

Step 18:
Prefold.

Step 17:
Valley-fold over the 2 lines at the bottom right, mountain-fold over the 2 diagonal lines and valley-fold over the 2 lines at the top left.

Step 22:
Open both flaps, see the 2 outer arrows.
Then squash-fold them, use the next picture as guidance.

Step 28:
One leaf done.

Step 25:
Fold over these 2 lines.

Step 26:
Press flat, see arrows.

Step 24:
Fold over this line.

Step 23:
Turn the model

Step 29:
The main stems are made by folding long papers around a metal / florist wire.

Step 27:
Fold the stem in half and curve it a little

Step 30:
The tiny stems are made by folding small squares in half a few times.

Step 31:
Fold both ends of a tiny stem sidewards, glue a flower to one end and glue the other end to the main stem. And glue a leaf to the main stem.

Step 32:
Glue more flowers and leafs to the main stem

Step 33:
This is one main stem with flowers.
Three are enough for one nice arrangement.