Only the front of the square piece of paper is coloured.
Step 1:This is the front of the paper.
Turn the paper.
Step 2:
Make a valley-fold over the yellow line.
Unfold this fold after you made it.
Step 3:
Make a valley-fold over these 2 lines.
Step 4:
Make a valley-fold over this line.
Unfold this fold after you made it.
Step 5:
Make in inside reverse fold over these 3 lines.
Do this by making a valley-fold over the 2 longer lines and
and a mountain-fold over the line in the middle.
Step 6:
Make the same folds as in step 5 over these 3 lines.
Step 7:
Fold the model in half, see the short lines in the middle.
Step 8:
Make a valley-fold over the yellow line so the piece on the right
of this line will stand straight up after you made this fold.
Make the same fold on the backside of the model.
You get a piece in the middle of the model which stands
straight up by making these 2 folds, see the arrows in the
picture of step 9.
Step 9:
Make the piece indicated by the arrows flat by pressing
on it from above.
Step 10:
Make a mountain-fold over these 4 lines.
Step 11:
Make a mountain-fold over these 2 lines.
Step 12:
Press on the model on the places indicated with the 2 arrows.
Hold the model the same way as I do in the picture of step 13.
Step 13:
Press the model upwards from below on the places indicated
with the 2 arrows (keep holding the model with your other hand
while you do this).
Do the same as above on the left side of the model.
The origami bow is ready!
