Step 1:The backside of this paper is completely white.
Prefold over these 4 lines.
Then, turn the paper.
Step 2:
First, valley-fold over the 2 lines at the bottom right.
Then mountain-fold over the 2 lines in the middle.
And valley-fold over the 2 lines at the top left.
Step 3:
Valley-fold over these 2 lines.
Step 4:
Unfold the folds of step 3.
Step 5:
Fold the end at the bottom of the arrow upwards
by making a valley-fold over this line.
Step 6:
Press the edges downwards from above, see arrows.
Step 7:
Repeat steps 3 to 6 on the backside of the model.
Then valley-fold the flaps downwards over the middle line.
Turn the model after you've done this.
Step 8:
Valley-fold over this line.
Step 9:
Open the model on the place indicated by the arrow.
Step 10:
Make an inside reverse fold over these 3 lines
Step 11:
Repeat step 10 on this end, see arrow
Step 12:
Make an outside reverse fold over the 3 blue lines
(=valley-fold over each line). Mountain-fold over the
green line.
Fold the edge at the upper arrow to the edge indicated
by the arrow below.
Step 13:
Make an outside reverse fold over these lines.
Step 14:
Fold the tip of the model to the inside, see very short
blue line.
Step 15:
Hold the model between two fingers on the place
indicated by the yellow dot. Then press the end flat
from above and below with your other hand, see arrows.
Step 16:
Mountain-fold over this line, make the same fold
on the other side of the neck.
Step 17:
Mountain-fold over this line.
And mountain-fold on the tip of the head, see arrow
(fold just a tiny bit to the backside of the model).
Step 18:
Press the neck inwards, see arrow.
Fold the leg to the left on the place at
the upper-arrow.
of the arrow.
(=valley-fold over the line in the
middle and mountain-fold
