Step 1:Both sides of the paper are green. The eyes are on the
top left in this picture (a little hard to see).
Prefold over these 4 lines, then turn the paper.
Step 2:
Make a valley-fold over these 4 lines.
Step 3:
Turn the model.
Step 4:
First make a valley-fold over the 2 lines at the bottom right.
Then make a mountain-fold over the 2 lines in the middle.
And make a valley-fold over the 2 lines at the top left.
Step 5:
Fold the flap indicated by the arrow upwards by making
a valley-fold over the pink line.
Step 6:
Hold the flap between 2 fingers, see large arrows.
Then press it flat from above with your other hand,
see small arrow.
Step 7:
Make a valley-fold over these 2 lines.
Step 8:
Unfold the folds of step 7.
Step 9:
Pull the edge indicated by the arrow downwards by
making a valley-fold over the pink line.
Step 10:
Press the edges indicated by the arrows downwards
from above, see arrows.
Step 11:
Fold the triangular piece upwards by making
a valley-fold over this line.
Step 12:
Repeat steps 6 to 11 on the other 3 flaps.
Step 13:
Pull the 2 ends at the bottom of each arrow outwards,
in the direction of these arrows.
Step 14:
Fold the triangular piece to the inside of the model
by making a mountain-fold over the pink line.
Step 15:
Push the 2 ends towards each other again, see arrows.
Step 16:
Repeat steps 13 to 15 on the other 3 triangular pieces.
Turn and rotate the model after you've done this.
Step 17:
Fold the piece on the right of the pink line to the left
by making a valley-fold over this line.
Step 18:
Pull the end indicated by the arrow upwards by making
an inside reverse fold over these 3 lines.
Fold the tip of the leg to the inside of the model
by the yellow dot. Then press the tip of the leg flat with
each other by making a valley-fold over the short
a valley-fold on the same place at the layer below
each line.
