Step 1:This is the front of the paper, the backside is
completely white.
Turn the paper.
Step 2:
Prefold over these 4 lines.
Step 3:
First, make a valley-fold over the 2 lines below.
Then, make a mountain-fold over the 2 lines in the middle.
And make a valley-fold over the 2 lines on the upper-left.
Step 4:
Make a valley-fold over these 2 lines.
Step 5:
Unfold the folds of step 4.
Step 6:
Pull the end at the arrow upwards by making
a valley-fold over the orange line.
Step 7:
Press the edges indicated by the arrows downwards.
Step 8:
Repeat steps 4 to 7 on the backside of the model.
Step 9:
Fold the piece above the line downwards by making
a valley-fold as shown.
Make the same fold on the backside of the model,
see arrow.
Step 10:
Make an inside reverse fold over the 3 orange lines
on the right. You automatically make a mountain-fold
over the red line on the left when you are doing this.
Step 11:
Now the model looks like this from aside.
Step 12:
And the model looks like this from above.
Make an inside reverse fold over these 3 lines
(Mountain-fold over the line in the middle and
a valley-fold over the 2 outer lines).
Step 13:
And make an inside reverse fold over the short lines
on the right (mountain-fold over the line below and
a valley-fold over the upper line on the edge. Make
a valley-fold at the same place as the line below
on the layer at the backside of the model).
Step 14:
Fold the piece indicated by the arrow to the backside
by making a mountain-fold over the short orange line.
Step 15:
Now the model looks like this.
Turn the model.
Step 16:
Pull the layer indicated by the arrow outwards.
Step 17:
Fold the piece indicated by the arrow out of the model
by making a valley-fold over this line.
Then push the layer of step 16 inwards again.
Step 18:
Repeat step 16 and 17 on the piece at the backside,
see arrow.
One penguin is done!
