Home - Gallery
- Contact - My upper floor - Videos - Privacy Policy
A PAPER PLANE (MODEL MINESWEEPER)
Only the front of the square piece of paper is coloured.
Step 1:
This is the front of the paper.
Turn the paper.
Step 2:
Make a valley-fold over the orange line.
Unfold this fold after you made it.
Step 3:
Make a valley-fold over these 2 lines.
Step 4:
Make a valley-fold over the line on top.
The edge indicated by the upper arrow will lay on the same
place as the edge indicated by the arrow below after you
made this fold.
Make the same fold as above over the line below.
Step 5:
Make a valley-fold over this line.
Step 6:
Fold the piece on the right of the orange line to the left
by making a valley-fold over this orange line.
Step 7:
Fold the model in half over this line (=mountain-fold).
Step 8:
Make a valley-fold over this line. Let the wing stand upwards
a little bit when you make this fold.
Make the same fold as above on the backside of the model.
Step 9:
Make an inside reverse fold over the 3 lines on top, on the left.
Do this by making a mountain-fold over the line in the middle
and a valley-fold over the other 2 lines.
You actually just pull the corner indicated by the arrow upwards
by making these folds.
Step 10:
Now, make an inside reverse fold on top of the cockpit.
Do this by making a mountain-fold over the short orange line
and a valley-fold on the same place at the backside of the
cockpit.
You actually just push the top of the cockpit to the inside of
the model when you make these folds.
The paper plane is ready!
Make sure that the wings of the minesweeper stand a
little
bit upwards.
