You can use a gold- or silver-coloured piece of paper.
Only the front of the paper needs to be coloured.
Step 1:This is the front of the paper.
Turn the paper.
Step 2:
Fold the paper in half over the yellow line.
Step 3:
Make a valley-fold over these 2 lines.
Step 4:
Make a valley-fold over these 2 lines.
Step 5:
And make a valley-fold over these 2 lines.
Step 6:
Curl the model a bit, see arrow.
Do this by holding the model with one hand and
pushing the rest of the model down or up with your other hand.
Do this on several places of the model.
Make sure the open side of the model will be
on the inside of the ring.
Step 7:
Lay the model around a finger and look how long
it has to be to fit around the finger.
Remove the model from your finger and cut off
the piece you don't need.
Step 8:
Lay the 2 ends of the model against each other and
roll a piece of transparent tape around them.
The ring is ready!
