Home - Gallery
- Contact - My upper floor - Videos - Privacy Policy
ORIGAMI SAILBOAT
I have a video for folding a sailboat on this site too. The diagrams below are for a flat sailboat,
this one is much easier to fold then the one in the video.
Step 1:
This is the front of the paper. The backside is white.
Make mountain- and valley-folds over these 4 lines.
Unfold each fold after you made one.
Turn the model after you've done this.
Step 2:
Make a valley-fold over these 2 lines.
Step 3:
Make these folds from the edge of the model to the center,
not any further.
First, make a valley-fold over the 2 lines below. Then make
a mountain-fold over the 2 lines in the middle.
And make a valley-fold over the 2 lines on top.
Step 4:
Now the model looks like this.
Lay the model on the table the same as I did in the
picture of step 5.
Step 5:
Hold the model at the yellow dot between 2 fingers.
Then pull the end at the yellow arrow a bit to the right
while you keep holding the model at the yellow dot
with your other hand. Then make the whole model flat again
by pressing on it from both sides.
Do the same as above with the other end on the left.
Step 6:
Make a mountain-fold over this line.
Make this fold over the upper part of the sail.
Step 7:
Make a valley-fold over this line.
Step 8:
Make a valley-fold over this line.
If you like, you can add a little glue on the place indicated
with the arrow before you make the valley-fold.
Turn the model.
The origami sailboat is ready!
